Install Model Y Juniper mud flaps without drilling

01 Preparation

Check the set before starting

Confirm you have four position-specific mud flaps, ten mounting clips and ten screws. A trim-removal tool is not included. Work on a parked vehicle on a level surface and clean the wheel-arch mounting areas.

02 Position

Match each flap

Identify the front and rear pieces and their correct side. Hold each part against the wheel arch before fastening anything.

03 Mounting

Align the existing points

Position the flap so its holes meet the original wheel-arch mounting locations. Do not drill new holes or force a piece that does not align.

04 Fastening

Secure the mounting hardware

Install the supplied clips and screws at the aligned points. Tighten the screws only enough to hold the flap securely and avoid deforming the part or vehicle trim.

05 Inspection

Complete a final check

Check that every flap sits flush, remains clear of the tyre and is secure. Recheck the mounting hardware after the first drive.

Compare Tesla Model Y Juniper mud flaps and kit features →